The function and working process of conveying automatic sandblasting machine

Conveying automatic sandblasting machineIts main function is to remove impurities, variegated colors and oxide layers on the surface of the workpiece, thereby improving the mechanical properties and aesthetics of the surface of the workpiece. Specifically, it is to impact and cut the surface of the workpiece through abrasives, so that the surface of the entire workpiece becomes cleaner, and at the same time, different roughness can be obtained. The surface of the workpiece processed by the conveyor automatic sandblasting machine can not only be greatly improved in mechanical properties, but also extend the durability of the surface coating of the workpiece, and make the entire workpiece look more beautiful. Here is a brief introduction to the working process of the conveyor automatic sandblasting machine.

The working process of the conveyor automatic sandblasting machine mainly has the following steps: 1. Put the product that needs sandblasting on the automatic conveyor belt of the sandblasting machine, and then the automatic conveyor belt will send this product into the sandblasting room , The blasting room will automatically blast the product. 2. After the automatic sandblasting process is completed, the automatic conveyor belt will bring the product into the blowing room and perform the blowing process; 3. The automatic conveyor belt will take the product out, and then the staff will take the product out. At this point, the entire workflow is completed. In addition, the entire construction process of the conveyor type automatic sandblasting machine is completed automatically except for the upper and lower workpieces, which greatly improves the production efficiency of the entire sandblasting process.

According to its sandblasting process, the conveyor automatic sandblasting machine generally divides its internal work flow into four stations. The first three are sandblasting stations, which can be sandblasted for three different parts of the workpiece. Five spray guns are also installed inside the box. The positions of these five spray guns can be fine-tuned. The purpose of the conveyor automatic sandblasting machine is to ensure that the spraying requirements of different workpieces are met. The fourth station is a station specially used to clean the workpiece after sandblasting. It mainly uses the air curtain blowing method to clean the workpiece. This method can not only clean the workpiece, but also splash it. The sand in the groove of the workpiece is cleaned out, so as to prevent the sand from being carried out when the workpiece comes out of the conveyor automatic sandblasting machine, which will cause waste.