Talking about the working process of conveying automatic sandblasting machine
Conveying automatic sandblasting machineIts main function is to remove impurities, variegated colors and oxide layers on the surface of the workpiece, thereby improving the mechanical properties and aesthetics of the surface of the workpiece. Specifically, it is to impact and cut the surface of the workpiece through abrasives, so that the surface of the entire workpiece becomes cleaner, and at the same time, different roughness can be obtained. The surface of the workpiece processed by the conveyor automatic sandblasting machine can not only be greatly improved in mechanical properties, but also extend the durability of the surface coating of the workpiece, and make the entire workpiece look more beautiful. Here is a brief introduction to the working process of the conveyor automatic sandblasting machine.
The working process of the conveyor type automatic sandblasting machine mainly has the following steps: First, the product that needs to be sandblasted is placed on the automatic conveyor belt of the sandblasting machine, and then the automatic conveyor belt will send the product to the blasting room , The blasting room will automatically blast the product; the second is that after the automatic blasting process is completed, the automatic conveyor belt will bring the product into the blowing room and perform the blowing process; the third is the automatic conveyor belt will The product is taken out, and then the staff removes the product. At this point, the entire working steps of the conveyor automatic sandblasting machine have been completed.
According to its sandblasting process, the conveyor automatic sandblasting machine generally divides its internal work flow into four stations. The first three are sandblasting stations, which can be sandblasted for three different parts of the workpiece. Five spray guns are also installed inside the box. The positions of these five spray guns can be fine-tuned. The purpose of the conveyor automatic sandblasting machine is to ensure that the spraying requirements of different workpieces are met. The fourth station is a station specially used to clean the workpiece after sandblasting. It mainly uses the air curtain blowing method to clean the workpiece. This method can not only clean the workpiece, but also splash it. The sand in the groove of the workpiece is cleaned out, so as to prevent the sand from being carried out when the workpiece comes out of the conveyor automatic sandblasting machine, which will cause waste.
Related News
- Low energy consumption of small sandblasting machine
- Derusting and sandblasting machine uses compressed air as power
- Sandblasting machine manufacturers generally supply sandblasting machines
- The mobile sandblasting machine uses the power, flow rate and flow of compressed air
- The working principle of wet sandblasting machine uses sandblasting abrasive and liquid as the medium
- Environmental protection and energy saving sandblasting machine supporting requirements
- Conveyor automatic sandblasting machine adopts suction sandblasting
- The nozzle of the rotary automatic sandblasting machine adopts special high wear-resistant boron carbide material
- The composition of the pipe end thread mobile sandblasting machine
- With timing automatic sandblasting, inching positioning function
- Talking about the characteristics of rotary automatic sandblasting machine
- Factors affecting the effect of wood automatic sandblasting machine
- Overview of automatic wood sandblasting machine
- Overview of the control system of the automatic sandblasting machine
- Overview of anti-skid automatic sandblasting machine for automobiles
- Common faults and solutions of automatic sandblasting machine
- The main components of the automatic pipeline derusting and sandblasting machine
- Safety operation regulations of automatic sandblasting machine
- The principle and characteristics of frozen burr machine
- Operating common sense of automatic sandblasting machine